RigCrafty Runs in your browser · Nothing to install

Mouse Double Click Test

Click the left button normally, one click at a time. If your mouse sends two clicks for a single press, the test catches it and shows exactly how many milliseconds apart they were.

Left clicks
0
Double clicks
0
Fastest left gap
—

Click, scroll and press the side buttons here

This test needs a mouse or touchpad.

InputPressesDouble clicks
Left button00
Right button00
Middle button00
Back (side)00
Forward (side)00
Scroll up0—
Scroll down0—
Tilt left0—
Tilt right0—
Wheel jumps—0

Event log

    How to check your mouse for double clicking

    1. Keep the pointer inside the test area and click the left button at a normal pace — not as fast as you can.
    2. Do at least 30 clicks. Faulty switches often fail only once every 10 to 50 presses, so a few clicks are not enough.
    3. Watch the “double clicks” counter and the red lines in the event log. Each one shows how many milliseconds passed between the two presses.
    4. Repeat with the right button and the side buttons — any switch can wear out.

    Reading the result

    No red entries after 30 or more normal clicks means the switch is healthy. One or two flagged presses with gaps of 50–80 ms can simply be a very quick finger, so lower the threshold and try again. Repeated gaps under 30 ms are a clear sign of a failing switch, especially if they happen while you click slowly.

    Why mice start double clicking

    Most mice use small mechanical micro switches. Every click scrapes the contacts a little, and after millions of presses — or sooner with humidity and dust — they stop making a clean contact. Mice with optical switches do not have this problem, which is one reason many gaming mice now use them.

    Not a hardware problem?

    Check that the double-click speed in your operating system settings is not set extremely slow, and that no macro or rapid-fire setting is active in your mouse software. Then test every button and the wheel with the full mouse test.

    Frequently asked questions

    What is a mouse double click problem?

    It happens when one press of a button is registered as two clicks. Inside the mouse, a small metal contact closes the circuit; as it wears out, it can bounce and briefly open and close again, sending an extra click.

    How does the test know a double click is not intentional?

    Even very fast human double clicks have a gap of roughly 80 milliseconds or more between presses. Faulty switches produce gaps of just a few milliseconds. The test flags any two presses of the same button that are closer than the threshold you set.

    Which threshold should I use?

    The default of 80 ms catches nearly every faulty switch without flagging normal clicking. If you click extremely fast on purpose, lower it to 50 ms. Gaps under about 30 ms are almost always hardware.

    Can software fix double clicking?

    Some mouse software has a “debounce” setting that ignores very fast repeat clicks, and there are small tools that do the same. They hide the symptom, but the switch will usually keep getting worse.

    Is it worth replacing the switch?

    If you are comfortable with a soldering iron, replacing the switch costs very little and gives the mouse a new life. Otherwise, check the warranty first — double clicking is a common reason for a free replacement.

    Related

    More free tests